Sound Familiar?
A Warm Spot on the Floor, or Water You Can Hear but Not See
People with slab leaks rarely search for the term at first. They search for what they notice: a patch of tile that feels warm in one spot, the hiss of water somewhere under the kitchen when everything is off, a water bill that doubled, or carpet that is damp along one wall for no reason.
Slab leak detection and repair means finding a supply leak in the pipe running under or inside a concrete foundation, then fixing it by opening the floor at that exact point or by rerouting the line so the buried section is no longer used. Roswell 24/7 Plumbing handles both across Roswell in 30075 and 30076.
The detection comes first, and it has to be precise. Concrete is expensive to cut and patch, so the goal is one small, correct opening or none at all.
Roswell homes with basements and crawl spaces outnumber full slab houses, but slab additions, finished basements and garages on grade all have water lines in concrete. When one of those lines fails, it is an emergency because the water has nowhere to go but up and out.
In Roswell's townhome communities, such as Founders Mill and the Heritage at Roswell, the HOA may own part of the building, so check your association documents before any concrete is cut. Single-family homes in hillside neighborhoods are more often on crawl spaces or basements.
24/7 Emergency Line Open
Emergency Slab Leak: Water Coming Up Through the Floor
A slab leak is an emergency when water is seeping up through concrete, when a hot spot spreads across tile, or when the meter will not stop. Pressurized water under a slab keeps running until someone closes the valve.
- Close the main shutoff. This is the only way to stop a pressurized line under concrete.
- Shut down the water heater. If the leak is on the hot side, an empty tank should not keep firing.
- Pull up wet rugs and move furniture. Hardwood and laminate over a slab cup fast once water reaches them.
- Note any warm spots. A warm patch on the floor tells the technician the leak is likely on a hot line.
If the main valve will not close, tell us on the call so the emergency visit brings the right tools. Call (770) 214-4545.
Hear Water Under the Floor?
If water is not pooling anywhere, you can leave it on until the test, which helps the equipment hear the leak.
Where Slab Leaks Happen in Roswell
Roswell is not a classic slab-leak city. Its sloped lots mean many houses sit on crawl spaces or full and partial basements, where pipes are exposed and leaks are easier to reach. Slabs show up in single-level ranch homes, in many townhome communities along the Holcomb Bridge Road corridor, in newer construction and in the lowest level of basement homes.
When a slab does leak, hot-water lines are the usual culprit because heating and cooling cycles make the pipe expand and contract against the concrete. Copper under slabs can develop pinholes over time, and red clay soil that shrinks and swells with moisture adds stress where pipes pass through the concrete.
If you are not sure whether your leak is under the slab or in a wall above it, general leak detection answers that first.
Repair Options
Spot Repair, Reroute or Repipe?
The right fix depends on the pipe's history and where it runs.
| Option | What it involves | Best when | Trade-off |
|---|---|---|---|
| Spot repair | Open the slab over the leak, replace the damaged section, patch the floor. | A single leak in otherwise sound pipe. | Floor patching, and other old sections remain. |
| Reroute | Run a new line through walls or the attic and abandon the buried section. | Pipe has leaked before or runs under finished flooring. | Some wall and ceiling access. |
| Whole-home repipe | Replace the supply system throughout the house. | Multiple failures or failure-prone pipe material. | Largest project, longest lasting. |
When the supply system is polybutylene or otherwise failing throughout, a whole-home repipe ends up cheaper than paying for leak after leak.
Detection
How a Slab Leak Is Pinpointed
- 1
Confirm the loss
Meter and pressure tests on hot and cold separately.
- 2
Trace the line
An electronic locator maps the pipe route under the slab.
- 3
Listen and image
Acoustic sensors and thermal imaging find the exact spot.
- 4
Mark and advise
The spot is marked and the repair options priced.
Testing the hot and cold sides separately is the fastest way to cut the search in half. A thermal camera makes a hot-water leak under tile stand out as a warm bloom that follows the pipe route. Slab homes in nearby East Cobb get the same sequence.
What to Do Before the Leak Test
A few steps limit damage and make the leak easier to find.
- Check hot versus cold. Close the cold inlet valve on top of the water heater. If the meter stops moving, the leak is almost certainly on the hot side, and the rest of the house keeps cold water.
- Leave the water on otherwise. Detection equipment listens for water escaping under pressure. A fully shut-off system is harder to test.
- Protect the flooring. Pull up rugs and move furniture off any damp or warm area.
- Photograph and record. Take pictures of damp spots and write down meter readings with times. Insurers and the plumber both use them.
- Do not start cutting. Opening a floor on a guess usually means opening it twice.
If water is actively pooling or rising, close the main and call right away instead.
Garages and Driveways
Leaks Under a Garage Floor or Driveway
Some of the hardest leaks to find run under a garage slab or a driveway rather than the house itself. Water lines to a detached garage, a basement addition or an outdoor kitchen often cross under concrete, and a leak there can show up as damp concrete at a slab edge or water seeping near the foundation.
Once the leak is pinpointed, there are two choices. Saw-cutting the concrete to reach the pipe works when the leak is in one known spot. Rerouting the line around the slab or above it avoids the concrete entirely and replaces old pipe at the same time. We price both when both are realistic.
Cost
What Changes the Cost of a Slab Leak Repair
Most of the cost is access and floor restoration, not pipe.
Many homeowners policies help with the cost of accessing a slab leak and repairing resulting damage but not with the failed pipe. Keep the detection report and photos for the claim. Reroutes are planned work and get a free estimate.
Think you have a leak under the floor? Call (770) 214-4545.
Questions
Slab Leak Questions
Visible water coming up through concrete, a fast-moving meter or a hot spot that keeps growing all count as emergencies. A small, slow leak found during a routine meter test can usually be scheduled. In both cases the main should stay closed between uses until the line is repaired or rerouted.
The classic signs are a warm spot on a tile or wood floor, the sound of running water with every fixture off, a water meter that moves when nothing is on, damp carpet with no obvious source, and new cracks in flooring. Any two of those together make a slab leak test worth doing.
Fewer than in some Sun Belt cities. A lot of Roswell housing sits on crawl spaces or basements because of the sloped lots. Slab foundations show up more in some townhome communities, ranch homes and newer construction, and in the lowest level of homes with a partial basement.
A single leak in otherwise healthy pipe is often repaired in place. Pipe that has already leaked more than once, or pipe of a type prone to failure, is usually a better candidate for a reroute through walls or the attic, which leaves the old line abandoned under the slab.
Many policies help with the cost of accessing the leak and the resulting water damage, but not the failed pipe itself. Policies differ widely, so call your insurer with the detection report in hand.
A long-running leak can soften the soil under a slab and contribute to settling, especially in clay. That is a good reason not to let one run for months, although most slab leaks are found long before that becomes a structural issue.
A spot repair is often done in a day, plus time to patch the floor. A reroute can take one to two days depending on how far the new line runs and how much wall or ceiling access is needed.
Sources for This Page
Leak detection methods reflect standard acoustic, thermal and electronic line-locating practice. Foundation patterns reflect Roswell's sloped terrain and housing mix as described by local plumbing contractors. Soil behavior reflects Georgia Piedmont clay characteristics.
Written by the Roswell 24/7 Plumbing team and checked against the sources above. Last reviewed October 31, 2026.